At Solution home > AutoMaker Software > General you explain the various preferences sub-menus, however the Head EEPROM panel is nowhere explained (neither in the PDF manual ... correct me, if I'm wrong on this).
After all these years of using multiple Roboxes, I'm still slightly scratching my head of the Head EEPROM XYZB settings.
The following info should be added:
- XY defines the XY offset between the Nozzle 1 & 2 (in order to align them, e.g. on dual material printing)
- Z defines the height of each nozzle over the bed
- B defines the point at which the valves close
At Solution home > AutoMaker Software > General you explain the various preferences sub-menus, however the Head EEPROM panel is nowhere explained (neither in the PDF manual ... correct me, if I'm wrong on this).
After all these years of using multiple Roboxes, I'm still slightly scratching my head of the Head EEPROM XYZB settings.
The following info should be added: