-
Notifications
You must be signed in to change notification settings - Fork 0
All issues
Issue creation is restricted in this repository
Issues
is:issue state:open
is:issue state:open
Search results
- Status: Open.#57 In origin89hq/hardware;
- Status: Open.#56 In origin89hq/hardware;
- Status: Open.#55 In origin89hq/hardware;
- Status: Open.#50 In origin89hq/hardware;
- Status: Open.
Controller A rev A: CN9 pin 1 feeds board B from raw V12 with no current limit, as CN13 does in #24
bugSomething isn't workingSomething isn't workingStatus: Open.Controller A rev B: an accessory bus and 12 V output, and how a millivolt gas heater would be controlled
enhancementNew feature or requestNew feature or requestStatus: Open.Generator B rev B: route the relay chains through the commons, not NC to NO
bugSomething isn't workingSomething isn't workingStatus: Open.Controller A rev A: D1 and D7 protection ratings are not confirmed by maker datasheets
bugSomething isn't workingSomething isn't workingStatus: Open.Blender scene: the filed 2026-09-09 STEP imports stacked connector models at the board centre
bugSomething isn't workingSomething isn't workingStatus: Open.#38 In origin89hq/hardware;Controller A rev A: CN13 leaves about 9 V for a 4–20 mA tank sender, under common transmitters’ 11–12 V minimum
bugSomething isn't workingSomething isn't workingStatus: Open.Controller A rev B: the indicator LEDs are far brighter than needed
enhancementNew feature or requestNew feature or requestStatus: Open.